WD-40 SPECIALIST® CONTACT CLEANER

WD-40 Specialist Contact Cleaner is a solution that cleans oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment.

It rapidly penetrates hard- to- reach areas and dries quickly without leaving any residue.

FEATURES AND BENEFITS

• Dielectric strength up to 35,000 Volts per 0.1 inch
• Fast acting, non-conductive cleaner
• Penetrates quickly, fast drying and leaves no residue.
• RoHS compliance
• Perfect for cleaning electrical equipment, contacts and plastics

APPLICATION

• Circuit Boards / Controls / Electrical Assemblies / Printers and Copiers / Switches / Tape Heads and Precision Instruments
  *It is advisable to test on a sample before use. For all precision instruments, check with manufacturer. Prolonged exposure for rubber not recommended.

DIRECTIONS

• Isolate all electricity and allow hot surfaces to cool. Make sure all stored power is drained from the system. Shake can well before use.
• Hold can 15cm to 20cm away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove contaminants that may cause loss of electrical contact.
• Tilt surface while cleaning and allow any excess cleaner to run off.
• Allow product to dry completely and thoroughly vent the system before restoring power.

SPECS:

• Product Name: WD-40 SPECIALIST® CONTACT CLEANER
• Product Code: 35011
• Product Size: 200mL per can